Geranium cutting method

I would like to share with you the method of cutting flowers of the geraniums. Flower friends in hotter areas, it is recommended to insert geraniums in the fall.

First, choose the cutting season in the Suzhou area of ​​the south of the Yangtze River, spring inserted March to June is appropriate. Autumn is better from September to November. The weather is not too hot, and the temperature is not too low, which is conducive to reborn in small days.

Second, the cutting substrate can be used with fine yellow sand (stone sand), preferably "filled with slightly thicker sand (rice size) below), which is good for flowing water; fine sand (slightly thick, cutting layer is used) on top, which is good for water retention.

Third, the selection of cuttings geraniums is not too strict, as long as it is healthy branches, generally select 3-4 leaves at the top of the branches, from the upper leaf section half a centimeter (0.5cm) obliquely cut, The cutting mouth should be as flat as possible, and then the leaves on the lower two sections should be removed together with the petiole. The top leaves 2-3 leaflets. If the leaves are too large, you can cut half and reduce evaporation.

Fourth, the cutting time 竺 竺 插 插 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正 修正Insert into the sand, you can use the tool to dig a small ditch, then put the cuttings, and then fill the sand, you can also first use the sand with water (of course, with the sterilizing agent to dilute the liquid), more insurance, and then use the insert For a slightly thicker hard object, first insert a hole with a slightly deeper height under the cutting bar on the sand, then insert the cutting insert, then press it with a little pressure, then spray the water through the spray container.

5. Choose the potted pot for the first half of the month. Place the inserted pot on the strong scattered light without direct light. After half a month, the callus is about to form. You can move the pot to the half-yin and half-yang (one day can shine for a small half day). The place to go to the sun (if it is close to the summer sun is too strong, do not see direct light for safety), it is more conducive to growing strong roots in the batch.

Sixth, watering and watering is not very strict, after the first pouring, usually just spray water properly. In this way, the general easy-to-root root varieties can be planted in about 25 days, and most of the varieties are rooted for about 30 days. (If the second half is placed in the direct high-pressure light for several hours every day, it takes a few days to survive. It takes a few days to slow down. If you don't take root after the time is dug, as long as the lower part of the branch does not rot, you can still insert it (be careful not to hurt), manage it as usual, and it will take root in a while.

Grinding wheel flint lighter

Grinding wheel lighters, flint lighters, lighter categories, lighter factories, lighter manufacturers, lighter manufacturers, lighter wholesalers, lighter craftsmanship

Grinding Wheel lighter,Flint lighter,Lighter Category,Lighter Production,Lighter process

Hunan Feituo Automation Technology Co., Ltd. , https://www.feetoolighter.com