Launched electro-pneumatic servo tracking winding device

Shantou Far East Light Equipment Co., Ltd. has developed a photoelectric pneumatic servo tracking winding device. The device consists of a machine base, bearing support, take-up reel, hydraulic cylinder, guard arm, paper guide roller, pneumatic buffer roller, tension detection roller and tension automatic controller. At the time of winding, the tape is guided through a guide roller, passes through a pneumatic buffer roller, a tension detection roller, and reaches the tracking roller, and is then rewinded. When the diameter of the coil changes (this change occurs continuously during the winding process), the photodetector feedbacks the detected diameter change signal to the programmable controller PLC and issues an instruction to drive the swing arm to push the moving frame and The tracking roller gradually recedes as the roll diameter increases.
During light pressure contact winding, the tracking roller is close to the outer circle of the coil and passes through the tracking roller and enters the paper roll of the paper roll without wrinkles during winding, plus high-precision tension control. Avoid the bubbles generated during the winding process.
The device is equipped with a hydraulic escalator assembly. When the diameter of the paper roll reaches the preset winding diameter value, the whole machine will send an acousto-optic alarm signal and automatically stop. Lift the unloading arm to push the take-up reel onto the unloading arm. Button, discharge arm will remove the finished product. Pneumatic buffer roller operates under the PLC command of the PLC, and can cooperate with the tension detection roller and automatic tension controller to effectively reduce or eliminate fluctuations in winding tension caused by various factors such as rewinding and unwinding. influences.