22. Trim the rectangle created in step 21 using the method of trimming flip A above, as shown in Figure 23:
Next is to draw the die line.
23. The drawing of the die pattern is shown in Figure 24:
After the die pattern is completed, the imposition is left.
Note: The dotted line on the right side of the pattern A and the mark A is missing from the drawing die line. Please note: The above dimensions are not pre-discharged. During the imposition process, it is found that using a positive folio print will waste a waste. The location of the box, so the use of positive three open pattern imposition, in the large version of the fight ten mold, small version fight five mold, as shown in Figure 25:
Source: CHISDY